Taulia experience center

Article Number: 000008668

If you run program /TAULIA/BS_SYS_REFRESH in the background to clear the Taulia specific tables after a refresh and find the following message in the job log in SM37: Can not run this Program on

Note that this message will not fail the job itself, so it is important to always check the logs after the job has finished.
Since the program did not run the Taulia tables will still have data in it, e.g. there are entries in table /TAULIA/DD_TNROL.same system.
 

Why this happens

The program /TAULIA/BS_SYS_REFRESH has a failsafe to make sure that the program is not run in your production system. The program reads the production system from table /TAULIA/BS_SYS_R when it starts and shows it on the selection screen. If it does not find an entry in the table it will show the system ID of the current system and generate the message above.



What to do

Configure your production system ID in table /TAULIA/BS_SYS_R by adding an entry using transaction SM30. You can do this directly in the system you just refreshed, provided it is open for configuration, but it is best to do this in your development system and transport the value to your QA and production system so you do not have to perform this step the next time you do a refresh.
After the entry is maintained the program's selection screen will look something like:



Note that we used PRD as an example of the system ID of the production system, you will have to use the actual system ID of your system.